![]() To do this, you can train a hair dryer on the ice maker to melt any ice blocking the mechanism. Warm the hose and surrounding mechanism.Pull down the small metal clip off the housing that holds the fill tube (though not all ice makers have this clip). This is a white rubber-like hose that delivers water to the ice maker. Remove the ice bin from the refrigerator and remove any loose ice from the ice maker. Unplug the refrigerator or turn off the circuit breaker that supplies power to it.If your ice maker has frozen up, take the following steps to thaw it out: With this type of problem, you can have it repaired, but it’s often wiser, easier, and less expensive to replace the unit entirely. You can do this yourself, as discussed below, or have an appliance repair person do it. If the problem persists, consider replacing the ice maker and valve.Using a screwdriver if necessary, remove the ice maker, clean it thoroughly, and then reinstall it. Lift the bail wire to shut off the ice maker, and remove the ice bin.Find the water shut-off valve behind the refrigerator or under the sink, turn it off, unscrew the copper line from the back of the refrigerator, put the copper line in a bucket, turn on the valve, and see if water pours out. This means the valve and the solenoid are probably okay, but the water supply is not.īe sure the water supply line isn’t kinked behind or beneath the refrigerator (1/4-inch copper tubing is much better than plastic fill line to prevent kinks). If the ice maker doesn’t make ice but you can see the arm swing into motion and you hear a buzz for about 10 seconds, the water valve is asking for water that isn’t arriving. When it is locked in the upper position, it shuts off the ice maker. Make sure the bail wire above the ice tray is in the down position.Make sure the bail wire above the ice collection drawer is not locked in its upper position. Here are a few steps you can take to get your ice maker working. (Also note that your home’s water pressure may not be strong enough to serve an ice maker.) If the water’s route is blocked or the solenoid doesn’t work-or if the bail wire is lifted-the ice maker won’t make ice. When the ice collection bin is filled with ice, the ice raises a bail wire, shutting off the ice maker unit until the ice level in the bin drops. ![]() Consequently, the water fill valve turns on for a few seconds to fill up the ice mold again, and the cycle repeats. The ejection arm pushes the ice cubes out of the mold and into the ice collection bin. Then it turns on a small icemaker motor that rotates the ice ejection arm. Next, it turns on a heater to slightly warm the cubes so they will release from the ice mold. When the water freezes, the thermostat shuts off the water supply via a solenoid. The fill valve sends water through a fill tube into a mechanized ice maker assembly that includes an ice mold. The water supply line leads to the water fill valve in the refrigerator, which is controlled by an icemaker thermostat. Diagram of an ice maker’s parts.Īn ice maker receives water through a small, 1/4-inch water supply line that runs from the refrigerator to a water pipe (or a water filter). But before diving into dealing with ice maker problems, let’s look at how an ice maker works so you’ll have a better understanding of what might be wrong.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |